An application for DIAMETER, EDGE 1, and EDGE 2 mode. Additional measurement MODES can be defined by the user. Some examples are: CENTER (the center of the detected object), THRESHOLD measurements (min. or max. diameter), POSITION (the placement of an object) and ORIENTATION (the laterality of the detected object).
A typical application for EDGE mode. In this mode, a two dimensional profile of a moving or a stationary object can be measured.
Another application for the EDGE mode. By using 2 parallel sensors to measure the width or profile of a LARGE stationary or moving object.
An application for the GAP mode. Gaps can be measured between objects that are either stationary or in motion.
The use of 2 perpendicular sensors to measure the X and Y axis of the detected object.